Assignment#11 Technical Drawing

part2:

The hardest part of this project for me was figuring out the exact size. Fortunately, after practice, I became more and more proficient in drawing the front and back of the object, as well as the left and right sides.

 

part3:

In the beginning, I according to the sketch of his words before and after the first around different shapes according to the proportion with a ruler painted on paper, then they are cut out with a knife and ruler, the process took me an hour and a half, and then I will in every corner of the board with a knife, cut a hole in the wire through the hole to two cardboard spliced together, finally complete the whole 3 d form, it took me about four hours.

 

 

Leave a reply

Skip to toolbar